Surface preparation is critical to the outcome and longevity of the surface finish. All surfaces to be coated with Monocel Varnish should be clean and dry, free from wax, oil, grease and other contaminants. Fine sanding with 240-grit sandpaper, rounding off all sharp edges and corners, then thoroughly dust prior to application. A tack rag is recommended for dusting.

All previous paint, varnish, shellac or lacquer must be totally removed and stripped back to bare timber before coating with Monocel Varnish. If the surface has been previously coated with Monocel Clear Timber Varnish, the surface should be sanded back lightly removing and lifted or cracked film and thoroughly cleaned before recoating.

Ensure adequate ventilation during use.

ALWAYS test the product on a small inconspicuous area or off-cuts first to ensure the product does not react adversely with surface and ensure the product is suitable for your specific requirements.

Stir varnish thoroughly before and during use using a broad, flat paddle in an upward motion. Insufficient mixing can result in whitening of the coat. DO NOT SHAKE the contents as shaking will produce air bubbles which may become transferred and trapped onto the area of application.

Proper penetration of the first coat is very important. Thin the sealer coat with 10-15% clean mineral turpentine and apply to all end grains and joints before fixing. Use a good quality, soft brush, applicator pad, roller or low-pressure spray over the surface. (low pressure spray may require dilution)

For large areas, a short nap mohair roller is recommended.

Allow 4 hours for the sealer coat to dry then fill any imperfections with a suitable coloured putty

Monocel Clear Varnish is touch dry in approximately 4 hours at 25ºC and 50% humidity, a minimum of 6 hours drying should be allowed to properly dry through before sanding and recoating. Drying times are a guide only and longer drying times may be required in cooler or humid conditions.

Apply a further 2 coats for internal applications, or 3-4 undiluted coats if used externally. Allow at least 24 hours drying time between coats. Finely sand with 240- grit sandpaper before each coat ensuring you dust thoroughly.